Samsung WMN4070TT Guia Del Usuario página 2

Installing the wall mount
[ Check the type of the wall before installing.
Standard Installation Requirements by Wall Type
• Can only be mounted on a concrete or interior wall of sufficient thickness. Refer to the diagrams below.
Min. 50 mm
MDF
PW, etc.
With reinforcement
Min.
50 mm
Min. 10 mm
MDF, PW
–
NOTE
MDF = Medium Density
Fiberboard
PW = Plywood
• Cannot be mounted on unreinforced wall or drywall surfaces.
MDF, PW,
Concrete
0~24 mm
1
Fix the adjustable mount onto the wall as shown by the figure.
② ①
③
Fix the adjustable mount onto the wall with anchors and
screws ⓐ from ① to ⑥ in this order. (Moving the adjustable
mount while fastening the screws onto the wall makes it
easier to fasten the screws.)
If you cannot fasten the anchors and screws at the specified
positions, fasten them at the nearest possible positions.
Check the strength of the wall, and if the wall is insufficiently strong, reinforce the wall before installing the product on the wall.
The screws and anchors supplied with the product are to fix the product onto wood or concrete.
Check the material of the wall and use appropriate fixing screws depending on the type of material such as plaster board,
marble or iron plate.
Min. 30 mm
MDF, PW
Art Wall
Min. 10 mm
MDF, PW
Min. 30 mm
Concrete
Art Wall
Min. 10 mm
MDF, PW
Art Wall Without
reinforcement
Cannot install on drywall
④ ⑤
⑥
Min.
25 mm
MDF, PW
(Exc. drywall
thickness)
Min.
25 mm
Mixed Concrete
Wall (Exc. drywall
thickness)
Drywall
Fixing the anchors and screws ⓐ
Drill a hole using a 9X70 drill bit.
(WMN-2370: 4X25)
Clean the inside of the hole.
Insert the enclosed anchor into the hole.
Align the adjustable mount with the hole
and fasten the screw
 When you drill a hole in the wall, make sure to use a drill
bit with the specified diameter.
Failing to do so may result in a safety issue.
ⓐ
.