Descargar Imprimir esta página

Craftsman 917.377700 Manual Del Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

TO CLEAN AIR FILTER
1.
Remove
cover.
2. Carefully
remove
cartridge.
3. Clean
by gently tapping
on a flat
surface.
If very dirty, replace
cartridge.
ACAUTION"
Petroleum
solvents,
such
as kerosene,
are not to be used to clean
cartridge.
They may cause deterioration
of
the cartridge.
Do not oil cartridge.
Do not
use pressurized
air to clean or dry
cartridge.
4.
Install cartridge,
then replace
cover.
Filter
Filter
Cover
Tabs
Tabs
MUFFLER
Inspect and replace
corroded
muffler as it
could create
a fire hazard
and/or
dam-
age.
SPARK
PLUG
Replace spark plugs at the beginning of
each mowing season or after every 100
hours of operation, whichever occurs first.
Spark plug type and gap setting are
shown in "PRODUCT
SPECIFICATIONS"
in Maintenance
section of this manual.
CLEANING
IMPORTANT:
For best performance,
keep mower housing
free of built-up
grass and trash. Clean
the underside
of
your mower after each use.
_I, CAUTION:
Disconnect
spark plug wire
from spark plug and place wire where
it
cannot come in contact
with the spark
plug.
• Clean the underside
of your lawn
mower
by scraping
to remove
build-up
of grass and trash.
• Clean engine often to keep trash from
accumulating.
A clogged
engine runs
hotter and shortens
engine life.
• Keep finished
surfaces
and wheels free
of all gasoline,
oil, etc.
• We do not recommend
using a garden
hose to clean
lawn mower
unless the
electrical
system,
muffler,
air filter and
carburetor
are covered
to keep water
out. Water in engine can result in
shortened
engine
life.
AWARNING:
To avoid serious
injury,
before
performing
any service
or adjust-
ments:
1. Release
control bar and stop engine.
2.
Make sure the blade and all moving
parts have completely
stopped.
3.
Disconnect
spark plug wire from spark
plug and place where
it cannot
come
in contact
with plug.
LAWN MOWER
TO ADJUST
CUTTING
HEIGHT
See 'qO ADJUST
CUFFING
HEIGHT"
in
the Operation
section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize
the possibility that objects will
be thrown out of the rear of the mower
into the operator's mowing position. If the
deflector
becomes
damaged,
it should be
replaced.
TO ADJUST
HANDLE
The handle on your lawn mower has
three (3) height positions - adjust to
height that suits you.
• Squeeze
the bottom
ends of lower
handle
towards
each other until the pin
in handle can be inserted
into one of
the three height
adjustment
holes.
Hi
Handle pin
Medium.
SQI
Low
Handle
15

Publicidad

loading