Publicidad
Idiomas disponibles
Idiomas disponibles
NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
Operation
1.
Position the fan heater so that it stands
upright on a firm, level surface, and at a
safe distance from wet environments and
flammable objects.
2.
Set the Thermostat Control Dial to the
highest setting. This is to the right on the
221A-120 and to the left on the 222A-120.
On the 221A-120, turn knob all the way to
the right to achieve the highest setting. It
is past the printed markings.
3.
Connect the fan heater to the proper
electrical power.
4.
The fan heater will switch on when the
Function Control Dial is set to one of the
four power settings.
Setting
Unit is Off
Fan Runs - No heating
Fan Runs - Low Heat
Fan Runs - High Heat
5.
When using the heater for the first time,
you may notice a slight emission of smoke.
This is normal and will stop after a short
time. The heating element was coated with
a layer of protective oil during production.
The smoke is caused by the leftover oil as
it is heated.
© 2023 Pinnacle Climate Technologies, Inc.
Operation
Function
Automatic Overheat Safety Control
–
This heater is equipped with safety internal
heat limiting thermostat and overheat
protection circuit. When a potential
overheat temperature is reached, the
system will automatically shut off the
heater.
Thermostat Instructions
–
Set the Thermostat Control to the highest
setting and let the heater operate with full
power input. When the room temperature
reaches the required value, turn the
thermostat down until it switches off.
–
The thermostat will then switch on and
off automatically to control the room
temperature according to the preset value
and keep the room temperature constant.
3
Electric Fan Heater User's Manual • REM-221A-120 / REM-222A-120
Publicidad
