Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1.
Mounting: The EBP can be mounted inside a fixture
channel, on the back of a fixture, or near the fixture.
The flex conduit should be connected to a junction
enclosure that allows access to the wiring connections
for grounding.
(Note: EBP assemblies without conduit must be factory
installed in the wireway of the fixture.)
Figure 1 - Emergency Battery component list
Components: Emergency Battery (A), Driver Bracket (B),
Emergency Bracket (C), Battery MTG Screw (D), Bracket MTG
Screw (E), Test Switch (F) – Numbers in Bracket indicate
Quantity
Mounting to back of fixture
i.
(a) Secure battery (A) to back side of LED Panel (X),
refer whichever Fig.2 best matches with available
CBRK fixture in the field.
(b) Use Driver Bracket (B) provided in Emergency Kit,
if the existing fixture is available with smaller driver
(20W/ 30W).
(c) If the existing fixture in the field is with bigger driver
(40W), then scarp driver bracket (B).
Figure 2- Emergency bracket and emergency battery
mounting on to backside of fixture
Installation Instructions – CBRK Emergency Battery Packs
(X)
CBRK with 20W/ 30W driver and Non-Sensor Option
CBRK with 40W driver and Non-Sensor Option
CBRK with 20W/ 30W driver and Sensor Option
CBRK with 40W driver and Sensor Option
COOPER LIGHTING SOLUTIONS
IB519148EN
OR
OR
OR
Installation instructions
3
Publicidad
