Publicidad
Idiomas disponibles
Idiomas disponibles
Clean Filter
The "Clean Filter" light will come on to tell you it is
time to change
your film_:
GEAppliances.com
Do Not Operate in FreezingOutdoor Conditions
This cool-only air conditioner
was not designed
for
fleezing
outdoor
conditions.
It must not be used in
fleezing
outdoor
conditions°
Remote Control
To ensure
proper
operation,
aim die remote
control
at the signal receiver
on the air
conditioner
The remote
control
signal has a range of
up to 20 feet°
Make sure noflfing
is between
file ah conditioner
and the remora
conuol
that could block the
signN.
N Make sure baueries
are flesh and insmUed
cotter@
_ksindicated
on the remote
control
Cool Mode
Use the Coo/mode at LOw, Med, High or Auto Fan
Speed for cooling.
Use the Temperature Increase A /
Decrease
T pads to set the desired
mmperamre
between
62°F and S6°F in 1 °F increments.
An electronic
themlosmt
is used to maintain
the
room mmperamre.
The compressor
will wcle on
and off to keep the room at the set level of comfort.
Set the themlostat
at a lower nmnber
and the indoor
air will become
cooler
Set the thermostat
at a higher
nmnber
and the indoor
air will become
wamler
NOTE." If the air conditioner is off andis then turnedon
while set to a Cool setting or ff turned from a fan setting
to a Cool setting, it may take approximately3 mbutes
for the compressorto start and cooling to begb.
Cooling Descriptions
For Normal Cooling--Select
the Cool mode and
High or Medfim
with a middle
set temperature.
For Maximum Cooling--Select
the Cool mode
and High fan with a lower set mmpemmre.
For Quieter and Nighttime Cooling--Select
the
Cool mode and Low fan with a middle
set
temperature.
Energy Saver Mode
Controls
the tim.
0N---The
tim will cycle on and offwith
the
compressor
This results in wider variations
of room
mmpemmre
and humidity.
Nomm/ly
used when
the
room is unoccupied.
NOTE: Thefan may continue to run
for a short time after the compressorcyclesoff
OFF--The
fan runs all the time, while the
compressor
cycles on and ore
Fan Mode
Use file EanMode
at Low, Medor Highfan
speed
to
provide
air circulation
and filtering
wifllout
cooling.
Since fire-only settings
do not provide
cooling,
a
Set mmperamre
cannot
be enmred.
The room
mmpemmre
will appear
in the display.
NOTE: AutoFanSpeed is available b the Fan Mode.
Auto Fan Speed
Set to Auto fhn speed
for the fan speed
to
automatically
set to the speed
needed
to provide
optimum
comfort
settings with the set temperature.
If the room needs
more
cooling,
the fan speed
will automatically
increase.
If the room needs
less
cooling,
the fan speed will automatically
decrease.
NOTE: AutoFanSpeed is available in the Fan Mode.
Power Outage Recovery Feature
In the case of a power outage
or interruption,
the
unit will automaficaUy
restart in the settings
last
used a[_er the power is restored.
If the
Delay 1-24hr
fe.amre was set, it will restmle
com_tdown.
You may
need to set a new dine if desired.
5
Publicidad
