Publicidad
Idiomas disponibles
Idiomas disponibles
STORING THE MOWER
See Figure 16.
WARNING:
While storing, keep at least 3 feet of clearance on all sides
of this product, including overhead. Allow a minimum of
30 minutes of "cool down" time before storage. Heat cre-
ated by muffler and exhaust gases could be hot enough
to ignite combustible objects.
Clean any grass clippings that have accumulated on the
underside of the mower deck.
Drain the fuel tank completely by running the mower until
the gas runs out. Stored gas can go stale in 30 days.
Store mower indoors in a clean, dry place out of the reach
of children.
• To store the mower in a horizontal position, lower the
handle assembly. Avoid pinching or trapping any cables.
• To store the mower in a vertical position, remove the
grass bag, then lower the handle assembly. Avoid
pinching or trapping any cables. Raise the mower 90°
to rest on its rear support.
NOTE: Make sure the pins on the handle adjustment knobs
are fully locked before attempting to raise the mower to the
standing position.
NOTICE:
Do not allow the starter cable to become pinched or
trapped when lowering the handle. Do not store near
corrosive materials such as fertilizer or rock salt.
FOR LONG-TERM STORAGE
Drain the lubricant and replace with fresh, clean lubricant
as described in Adding/Checking Engine Lubricant in
the Operation section of this manual.
MAINTENANCE
Disconnect spark plug wire and remove the spark plug.
Pour about a teaspoon of clean, air-cooled, four-cycle
lubricant through the spark plug hole into the combustion
chamber.
Leaving the spark plug out, pull the starter grip and rope
two or three times to coat the inside of the cylinder wall.
Inspect the spark plug and clean or replace, as necessary.
Reinstall the spark plug, but leave the spark plug wire
disconnected.
Clean the air filter.
Extend the starter grip and rope rope to check its condi-
tion. If the rope is frayed, have it replaced immediately
by a qualified service center.
Wipe the mower clean with a dry cloth.
Check all nuts, bolts, knobs, screws, fasteners, etc., for
tightness.
Inspect moving parts for damage, breakage, and wear.
Have repairs made on any damaged or missing parts.
Check blade for damage, uneven, or excessive wear and
replace blade if these conditions exist.
Lower the handle assembly as described earlier in this
manual. Avoid pinching or trapping any cables.
Store mower indoors in a clean, dry place out of the reach
of children.
Do not store near corrosive materials such as fertilizer or
rock salt.
Never store the machine or fuel container where there is
an open flame, spark, or pilot light such as on a water
heater or on other appliances.
Page 13 — English
Publicidad
