Publicidad
Idiomas disponibles
Idiomas disponibles
3.
There are two methods of mounting the brackets. In the case of permanent
installation of the ramp, e.g. in municipal buildings, the bracket should be
mounted as shown on the picture 1. This will make the ramp stable and will not
move. For temporary installation, the bracket should be mounted as shown on
the picture 2. This method of installation does not provide the same stability as in
the case 1, but the bracket can be easily removed.
4.
The ramp has an additional, factory-installed bracket that does not require
assembly or disassembly. It should be used when the ramp is installed at the
height of 65–100 cm and its length is 3–4 m.
5.
Regularly check and tighten nuts as necessary to prevent loss or twisting. If any
parts or fasteners are deformed due to an overload or an impact, please stop
operation and replace the deformed parts or fasteners in reasonable time.
6.
Joints between the steps of the ramp should not be aligned.
7.
When using the ramp, use mounting plates. They prevent the ramp from sliding
off the platform and moving sideways. Mounting plates should be mounted to the
ramp and to the ground with screws.
Publicidad
