Tools required
• Pliers
Break blade
1. Only push the blade out of the hous-
ing up to the predetermined breaking
point, otherwise more than one seg-
ment may break off.
2. Grasp the blade with pliers near the
predetermined breaking point.
3. Break the blade in such a way that the
pliers are rotated around their own
axis and the breaking point is pulled
apart. This causes the bar to break off
sharply.
Replace blade
1. Push the slider (23) on the carpet knife
(22) forwards as far as it will go.
2. Remove and dispose of the blunt blade
properly.
3. Push the slider (23) on the carpet knife
(22) backwards as far as it will go to
use a new blade.
Filling the magazine
1. Press the release (21) on the carpet
knife (22) to pull out the magazine
with the replacement blades to the
rear.
2. Insert the new blade into the
magazine. An opening is punched in
the rear end of the blade into which
the slider is hooked.
3. Push both back into the guide until the
magazine with the replacement blades
clicks into place.
Checking the battery charge
level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (11) next to the
charge level indicator button (12) on
the battery (13).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (13) when only the
red LED on the charge level indicator
(12) is illuminated.
Charging the battery
See also the charger instruction manual.
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (13) from the
device.
2. Push the battery (13) into the charging
slot of the battery charger (31).
3. Connect the battery charger (31) to a
power outlet.
4. After charging, disconnect the battery
charger (31) from the mains.
5. Pull the battery (13) out of the battery
charger (31).
GB
MT
Meaning
Battery partially
charged
Battery needs to be
charged
35