JANE 6009 Instrucciones De Uso página 5

UNLOCKING THE HEIGHT REGULATION MECHANISM
(see attached drawing)
Unlock the height regulation mechanism safety lock, situated in its vertical
position "CLOSE", by PUSHING the safety lock inwards while turning it anti-
clockwise to the "OPEN" position.
INSTALLING THE BOUNCER
Open the metal arms to install the bouncer centred above the doorframe (check that the frame complies with
the safety requirements set out in this manual).
Once the top clamps are correctly adjusted above the doorframe, slowly release the metal arms until the top
clamps are correctly adjusted with the wall.
ADJUSTING THE HEIGHT OF THE BOUNCER (see attached drawing)
Take each of the belts in one hand just beneath the locking box and adjust
the bouncer to the desired height, tautening one side and slackening the
other, or vice versa, to raise or lower the bouncer.
Note: the correct height of the bouncer will let the baby touch the floor on
tiptoe. You should remember that when you place the baby in the bouncer,
it will lower by about 8 cm.
Once you have adjusted the height, and ALWAYS before placing the baby in the bouncer, you must lock the
height adjustment mechanism by turning the control from the "OPEN" position to the vertical "CLOSE" position
(only in this position is the height adjustment mechanism locked, and it is only when it is in this position that you
can safely place the baby in the bouncer).
IMPORTANT
With the bouncer installed and ALWAYS before placing the child in it, check the following points:
Check that the locking control is in the CLOSE position.
Check that the bouncer is correctly installed by tugging hard on the belt that supports the bouncer vertically,
then place the child in it correctly and adjust the safety belt.
UNINSTALLING THE BOUNCER
Carry out the procedure in reverse.
CLEANING THE BOUNCER
Clean the plastic parts with a damp cloth with soap and water.
WASHING THE FABRIC
Place the bottom base face downwards, and with the help of clips gently pull the 8 white flaps, pulling them over
the central slot. By gently folding the 8 white flaps, this is much easier. Once the flaps have been unfastened,
move them inside to remove the fabric.
Wash the fabric by hand and let it dry at room temperature.
To put the fabric back again, carry out the procedure in reverse.
Please note that the fabric has a single position and its interior shape should match the shape of the bottom base.
The seat support and that of the bottom base should coincide.
Place the plastic flaps one by one in an identical position to how they were before disassembly, check that ALL
the flaps are locked by each of the central slots.
5
CLOSE OPEN