Publicidad
Idiomas disponibles
Idiomas disponibles
Plugging in the Origin Camera
1
1. Remove the main lens cap by rotating the
cap counterclockwise slightly to unlock it.
Then, lift the cap straight out to remove it.
Using Origin
You are now ready to take your telescope outside and begin your journey into astroimaging.
1. Find a good place to set up Origin. You'll have the most fun and best results in a loca-
tion that gives you the greatest access to the sky, free from buildings or trees.
2. Turn on your Origin using the switch at the base of the fork arm.
3. Use the WiFi settings in your iOS or Android device to connect to the Origin's WiFi
signal, which has the ID "Origin-XXX".
4. The first time you connect, your device will prompt you to enter the Wi-Fi password. The
temporary password for the Origin network is "12345555". For your security, you should
change this password to something more personal using the options in the Setting
Menu. Your device will remember this password, so you will not need to re-enter it the
next time you use that device to control Origin.
NOTE: If you connect to Origin's Wi-Fi through the Origin App setup screens, you will not
be required to enter the password.
5. Launch the Origin App and follow the on-screen instructions.
FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
Product design and specifications are subject to change without prior notification.
This product is designed and intended for use by those 14 years of age and older.
4 | ENGLISH
2
2. Remove the foam camera support from
inside the lens shade by pulling it straight
out. This foam was designed to protect
the camera during shipping. You do not
need to reinstall it each time you store
your Origin. However, we recommend
that you hang onto this foam and use it if
you ship Origin anywhere in its original
packaging.
3
3. Plug the end of the USB camera cable
into the port on the back of the camera.
Plug the other end into the USB port on
the inside edge of the lens shade.
For complete specifications and warranty information, visit:
celestron.com/support/warranties
© 2024 Celestron • All rights reserved
celestron.com/pages/technical-support
2835 Columbia Street • Torrance, CA 90503 USA
01-24
Power
switch
Publicidad
