Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Selecting the mouthpiece
Use one of the supplied mouthpieces that suits the
■
diameter of the blind rivet [6] to be used.
Replacing mouthpiece
Unscrew the mouthpiece [2] with the supplied
■
spanner.
To facilitate loosening the mouthpiece, keep the
■
levers of the rivetting tongs pressed together.
Take the appropriate mouthpiece [2] out of the
■
holder and screw it to the head [4] using the
spanner [3].
Working procedure
Pull the levers [1] apart.
■
Put the blind rivet [6] in the mouthpiece [2].
■
Insert this blind rivet [6] in the hole of the parts to
■
be joined.
Press the levers [1] firmly together.
■
3 The rivet shank is compressed.
3 The rivet mandrel breaks off at the pre-determined
breaking point.
Note
If the shank does not break off at
the first time, repeat this procedure
as often as necessary, i.e. open and
press the lever together until the shank
breaks off.
Ejecting rivet mandrel
Pull the levers [1] of the rivetting tongs apart and
■
move the tongs.
3 The rivet mandrel is ejected at the back of the
head.
Maintenance / Care
Clean the clamping jaw from dirt and zinc deposits
from time to time.
If the clamping jaws are worn, replace them by genu-
ine Würth accessories.
Accessories / Spare parts
Mouthpiece 2.4 mm for aluminium
blind rivets;
inner Ø of the mouthpiece 1.7 mm
Mouthpiece 3.0 / 3.2 mm for
aluminium and A2 blind rivets;
inner Ø of the mouthpiece 2.3 mm
Mouthpiece 4 mm for steel and
A2 blind rivets;
inner Ø of the mouthpiece 2.9 mm
Mouthpiece 5 mm for blind rivets
made of aluminium alloy;
inner Ø of the mouthpiece 3.2 mm
Spare clamping jaws
Environmental protection
Do not dispose of the device with
domestic waste. Have the device
disposed of by an authorised waste
management company or your
municipal waste management
organisation. Adhere to the applica-
ble regulations. In case of doubt
contact your waste management organisation.
Recycle all packaging material in an environmentally
friendly manner.
Warranty
This Würth device is covered by warranty according
to the applicable national regulations. The warranty
period begins on the date of purchase (please retain
invoice or delivery note as proof of purchase).
Faults covered by warranty shall be eliminated by
replacement or repair. Damage caused by improper
operation is not covered by warranty.
Claims can be recognised only if the device is in a
non-disassembled state and presented to a Würth
branch office, your Würth sales representative or a
customer service office authorized by Würth.
Technical changes reserved.
We accept no liability for printing errors.
Art.
0946 10 18
0946 10 24
0946 10 29
0946 10 32
0946 10
9
Publicidad
