American Standard Colony Pro 7075100 Manual Del Propietário página 6

6
SERVICE
Turn off hot and cold water
supplies before beginning.
• To remove or replace cartridge:
– Turn valve to OFF position.
– Pull out PLUG BUTTON (1) and remove HANDLE
SCREW (2).
– Pull off HANDLE (3) and CAP (4).
– Pull out CARTRIDGE (5).
– Inspect CARTRIDGE (5) and O-RINGS (6) for
debris and clean if necessary.
– Clean MANIFOLD (7) and rinse clean.
– Reinstall CARTRIDGE (5) and O-RINGS (6) onto
MANIFOLD (7).
– Reinstall CAP (4) and HANDLE ASSEMBLY (3).
• If spout drips, operate handle several times from
OFF to ON and HOT to COLD position.
Do not force - handle turns only 90˚.
ADJUST HOT LIMIT SAFETY STOP
By restricting HANDLE rotation and limiting the
amount of hot water allowed to mix with the cold,
the HOT LIMIT SAFETY STOP (8) reduces risk of
accidental scalding. To lower the maximum hot
water temperature of your faucet, all you need to
do is adjust the setting on the HOT LIMIT SAFETY
STOP (8).
Note: The HOT LIMIT SAFETY STOP (8) is set at the
neutral setting from the factory. Fig. A.
• To adjust HOT LIMIT SAFETY STOP:
– Remove HANDLE ASSEMBLY (3), CAP (4)
– Set the CARTRIDGE STEM (9) to the OFF position.
– Lift up the HOT LIMIT SAFETY STOP (8).
– Place the HOT LIMIT SAFETY STOP (8) in the
desired GRAY SHADED AREA (10) to limit the hot
water. Fig. B.
– Reinstall CAP (4) and HANDLE ASSEMBLY (3).
7
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL
CLOTH. DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
1
2
9
8
A
COLDER
+HOTTER
9
SETTING
MARKS
8
B
10
7
2.5mm HEX KEY
3
4
5
6