KNOW YOUR PRESSURE WASHER
Read the Operator's Manual and safety rules before operating your pressure washer.
Compare the illustrations with your pressure washer to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
Recoil Starter
Fuel Tank
Air Filter
Throttle Lever
& Choke Lever
Air Filter — Protects engine by filtering dust and debris out of
intake air.
Automatic Cool Down System — Cycles water through pump when
water reaches 125°-155°F. Warm water will discharge from pump
onto ground. This system prevents internal pump damage.
Cleaning Tank – Used to provide HydroFoam™ wash or other
detergent to the low pressure water stream.
Choke Lever — Prepares a cold engine for starting.
Fuel Tank — Fill tank with regular unleaded fuel. Always leave room
for fuel expansion.
High Pressure Hose — Connect one end to the water pump and the
other end to the spray gun.
High Pressure Outlet — To connect high pressure hose.
HydroFoam™ Launcher — Use to apply HydroFoam™ wash or
other detergents designed specifically for pressure washers.
FEATURES AND CONTROLS
Spray Gun
Cleaning Tank
Nozzle Extension with
Quick Connect
Pump equipped with Automatic
Cool Down System
Nozzle Extension with Quick Connect — Allows you to switch
between three different spray nozzles and HydroFoam™ Launcher.
Oil Fill Cap/Dipstick — Check and fill engine with oil here. See
page 19 for oil recommendations and filling instructions.
ProjectPro® Nozzles — Max, General, and Delicate Nozzles: for
various cleaning applications.
Pump — Develops high pressure.
Recoil Starter — Use for starting the engine manually.
Spray Gun — Controls the application of water onto cleaning surface
with trigger device. Includes safety latch.
Throttle Lever—Sets engine in starting mode for recoil starter and
stops a running engine.
Water Inlet — Connect garden hose here.
6
ProjectPro® Nozzles
HydroFoam™ Launcher
High Pressure Hose
Oil Fill Cap/Dipstick
High Pressure Outlet &
Water Inlet