Additional Information - Sunbeam HD3002 Manual De Instrucciones

MOUNTINg INSTRUCTIONS
For use on sheetrock or wood walls only.
The Sunbeam®Wall Mount hair dryer is designed for
installation on sheetrock or wood walls only. To mount
onto wall, be sure there are no hidden electrical circuits
or pipes in the mounting location.
1. Remove wall bracket from the unit.
2. Use the bracket as a template to mark the position of
holes for drilling close to electrical outlet, away from
tub or sink.
3. Drill three 3/16 inch holes.
4. Insert the three anchor bushings by tapping lightly
with a hammer until the shoulder of the bushing rests
against the wall.
5. Position wall bracket and tighten the two bottom
screws first, then tighten the top screw. (Anchor
bushings and screws are provided for you).
6. Match the slots on the back of the mounting base with
the hooks on the bracket.
7. Press base onto the hooks and slide down to insure
secure mounting.
8. Plug the unit into the nearby electrical outlet (125 volt,
60 cycle AC only).
dANgER – To reduce risk of electrocution, do not install where unit can fall into tub or sink.
Features of Your Hair dryer
Wall Mounted
Base
Nightlight
(Model
HD3003 only)
3 Speed/Heat
Slide Switch
Test
Button
Nightlight
On/Off
Dimmer Switch
Reset
(Model
Button
HD3003 only)
Note: HD3002 and HD3003
have been designed to be
compatible with existing
1632-040/1632-020 hair
dryer brackets
BRACKET
Anchor
Bushing
Air Outlet
Cool Shot
Button
Wattage Switch
Cord Guard
4
This dryer is equipped with an appliance leakage circuit interrupter (ALCI) for your safety. This
device is designed to make the appliance inoperable under some abnormal conditions (such
as accidental immersion in water).
After the appliance is plugged in, you must check your protective device as follows:
1. Press the "Reset" button on the ALCI device.
2. Press the "Test"' button. The "Reset" button will pop out. This verifies that the protective
device is working properly.
Screw
3. Press the "Reset" button once more to reactivate the safety device and use your appliance.
REPEAT THE AbOvE PROCEdURE bEFORE EACH USE
TO CONFIRM THAT THE PROTECTIvE dEvICE IS OPERATINg.
The Hair Dryer has three heat/air speed settings. To control the heat/air speed settings,
toggle the switch to the desired temperature and speed.
With the control setting switch in the "OFF" position, plug the Hair Dryer into a standard 125-
volt AC outlet. Select the setting that is most appropriate to your needs and that will deliver
the best results.
When finished using the Hair Dryer, move the control switch to the "OFF" position and unplug
the cord from the outlet.
Hinged Air
Intake Grill
COOL SHOT BUTTON (Refer to Diagram)
To finish styling, use the
DISPOSABLE LINT FILTER
Disposable Lint Filter should be replaced every 6 months. Open hinged rear cover, remove
Disposable
and discard lint filter and replace with new one.
Lint Filter
DUAL WATTAGE SWITCH
This switch allows the Hair Dryer to change from 1500 to 1200 watts. The switch is located
under the hinged rear cover.
Dual
NIGHTLIGHT (Model HD3003 only)
Use the Dimmer Switch located on the lower portion of the wall mount to turn the nightlight
on/off and to adjust desired brightness.
Operating Instructions
To Use Your Hair dryer

Additional Information

Cool Shot Button to deactivate heat flow from the dryer.
5