Publicidad
Idiomas disponibles
Idiomas disponibles
1.Remove
battery from unit ( see
Battery
Removal and Installation on page 20).
2. Place battery in a well-ventilated
area.
3. Connect positive (+) lead of charger to
positive (+) terminal, and negative (-)
lead of charger to negative (-) terminal.
4. Charge battery according to battery
charger and battery manufacturers'
instructions.
5. Install battery on unit (see Battery
Removal and Installation on page 20).
Jump-Starting
Ariens does not recommend jump-starting
your unit. Jump-starting
can damage engine
and electrical system components.
See your
engine manual for more detailed information.
ADJUSTING
STEERING LEVERS
Adjusting
Steering
Lever
Height
(Figure
19)
NOTE: Perform steps 1 and 2 for both
steering levers.
1. Remove mounting hardware and move
handlebar up or down until the steering
levers are at the appropriate height.
2. Install mounting hardware.
NOTE: Align handlebars by adjusting
eccentric spacer until the height of
handlebars are the same.
1. Handlebar
2. Steering Lever
3.
Mounting Hardware
4. Adjustment
Holes
5.
Eccentric Spacer
Figure 19
Forward
and Reverse
Speed
Adjustment
(Figure
20)
IMPORTANT: The unit should track within
2 feet (0.61 m) of a straight line for 30 feet
(9.14 m).
The travel of the steering levers may need
adjustment
if:
The unit turns to the right or left when
both steering levers are pushed as far
forward as possible.
The unit turns to the right or left when
both steering levers are pulled back as
far rearward as possible.
GB - 21
Publicidad
