Publicidad
All manuals and user guides at all-guides.com
Adjusting the volume
Set the volume of your sound source to a
medium value. With some devices, the volume
for the headphone output can be regulated
separately.
Use the V
control on the right earpiece
OLUME
to adjust the headphones´ volume.
Adjusting the receiver channel
First switch on the transmitter (see section
Where to place the transmitter). Then switch on
the headphone receiver - as soon as the receiver
is switched on it automatically tunes itself to the
first strong signal found (normally the transmitter
frequency). If, for some reason, the selected
channel is not the correct one (eg: because of
interference or another nearby system), press the T
and the auto-tune function will re-tune to the next strong signal. Repeat this until
you can hear the audio signal loud and clear. If you decide to change the
transmitter channel, the receiver search tuning must be re-started by pressing the
T
button on the headphones again
UNE
Changing the transmission channel
To avoid interference caused by the
simultaneous operation of several transmitters,
select a different channel on each transmitter.
Depending on the system variant, two or three
switchable transmission channels are available.
To select a channel, press the C
until the desired LED or LED combination
lights up:
LED 1
LED 2
LED 1 and 2
Complete freedom of movement
It is not necessary that transmitter and
headphone receiver are in a direct line of sight, so
you can move around freely in the home or
outside in the garden. One transmitter can be
used to transmit to several receivers on the same
frequency.
Additional headphones with the designation
HDR 65 are available from your specialist dealer.
Please make sure to choose headphones with the same frequency range as the
transmitter you are using (see type plate on the bottom of the transmitter).
Wireless RS 65-8
UNE
button
HANNEL
channel 1 active
channel 2 active
channel 3 active (except 863 MHz version).
button on the earpiece
Publicidad
