Publicidad
Idiomas disponibles
Idiomas disponibles
Electronic Alert & Diagnostic System
(continued)
The Electronic Alert and Diagnostic
System
alerts you when something starts to go wrong
If a system code appears
on the display,
something
needs special attention.
To get your
attention, the display code flashes until you erase it
The first 6 flashes are accompanied
by beeps
If more than one coded function
requires
attention
at the same time, the one with the highest priority will be
displayed first.
Pressing the SYSTEM CHECK-RESET pad will evaluate all
other coded functions_ If the NORMAL display is lit
during the displaying of a code, that function is operating
properly
Pressing the SYSTEM CHECK-RESET pad will erase
two codes immediately-PF,
and C1 The dE and
FF codes can only be erased
by touching
the
SYSTEM CHECK-RESET pad after the condition
that caused the code to flash has been corrected.
This flashing
code tells you the
power to the refrigerator
has
been interrupted
for more than
2 seconds, Check the condition
of food in both the fresh food and
freezer compartments, Touch
SYSTEM CHECK:RESET pad to
erase
code
There is no fault with the refrigerator
when
PF code flashes
This flashing code tells you
something's wrong with the defrost
system- keep doors
closed to
retain cold and call for service.
Code flashes until problem is
corrected
This flashing code tells you
to check your frozen food.
Has any of it started to thaw?
A package may be holding the
freezer compartment door open.
Don't open the door more often
than absolutely necessary while
this code is displayed
Touching
the SYSTEM CHECK-RESET pad after the freezer
compartment temperature has returned to normal will
erase the code
This flashing code tells you to
check the automatic
icemaker.
Ice clumps in the storage bin may
have stalled the icemaker. Follow
corrective measures described on
page 8 If water supply to the
icemaker is not connected or not
turned on, make sure manual
icemaker switch is in the STOP position_ Code stops
flashing when problem is corrected or SYSTEM CHECI(_
RESET pad is touched
Publicidad
