Descargar Imprimir esta página

Craftsman 917.388280 Manual Del Propietário página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGINE OIL
Drain oil (with engine warm) and replace
with clean engine oil (See "ENGINE" in
the Maintenance section of this manual)°
CYLINDER
• Remove spark plug_
• Pour one ounce (29 ml) of oil through
spark plug hole into cylinder.
• Pull starter handle slowly a few times to
distribute oil.
• Replace with new spark plugo
OTHER
. Do not store gasoline from one season
to another.
• Replace your gasoline can if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems_
• If possible, store your unit indoors and
cover it to give protection from dust and
dirt,
• Cover your unit with a suitable protec-
tive cover that does not retain moisture,
Do not use plastic. Plastic cannot
breathe which allows condensation
to
form and will cause your unit to rust,
IMPORTANT:
Never cover mower while
engine and exhaust areas are still warm,
4_IbCAUTION:
Never store the lawn
mower with gasoline
in the tank inside a
building
where
fumes
may reach an open
flame or spark.
Allow the engine to coo!
before
storing
in any enclosure.
TROU BLESHOOTING
CHART
,,
, ,,,,,, ,,,,,,,,,,
PROBLEM
Does not start
1,
2,
3,
4,
5.
6,
7.
8_
9.
Loss of power
1,
2.
3,
4,
,,,,,
,,,,
,,,
,,,i ,,,,,,................
Dirty air filter.
Out of fuel.
Stale fuel,
Water in fuel.
Spark plug wire is
disconnected.
Bad spark plug.
Loose blade or broken blad_
adapter.
Control bar in released
position.
Control bar defective.
Rear of lawn mower housing
or cutting blade dragging
in heavy grass_
Cutting too much grass,
Dirty air filter.
Buildup of grass, leaves,
CORRECTION
1.
Clean/replace air filter,
2,
Fill fuet tank_
3.
Drain tank and refill with
fresh clean fuel.
4,
Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
5,
Connect wire to plug,
6.
Replace spark plug.
7.
Tighten blade bolt or
replace blade adapter,
8_ Depress control bar to
handle,
9.
Replace control bar_
I,
Set to "Higher Cut"
position°
2,
Set to "Higher Cut"
position°
3,
Clean/replace air filter°
4,
Clean underside of mower
and trash under mower,
5.
Too much oil in engine.
6_ Walking speed too fast,
housing.
5,
Check oi! level
6,
Cut at slower walking
speed,
15

Publicidad

loading