Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!
IN ORDER FOR THE UNIT TO FUNCTION PROPERLY AND
SAFELY THE DEBRIS SHIELD MUST BE ATTACHED TO THE
GEAR BOX IN THE CORRECT POSITION. THE SHIELD CAN
BE ATTACHED IN A HIGH POSITION OR A LOW POSITION.
WHEN USING THE BLADE THE SHIELD MUST BE IN THE
HIGH POSITION.
WHEN USED AS A LINE TRIMMER THE SHIELD MUST BE IN
THE LOW POSITION-
SHIELD ASSEMBLY FOR LINE TRIMMER
(LOW POSITION)
THE BRACKET (FIG. 1) MUST BE MOUNTED TO THE
SHIELD WITH THE OPEN SIDE UP AS SHOWN. SECURE
THE BRACKET AND SHIELD TO THE GEAR BOX WITH THE 4
SCREWS INCLUDED. TIGHTEN THE SCREWS FIRMLY WITH
A 4mm ALLEN WRENCH.
SHIELD ASSEMBLY FOR BRUSH CUTTER BLADE
(HIGH POSITION)
Fig. 2
INSTALLING BIKE HANDLE ASSEMBLY
• Install the clamp assembly on the shaft tube.
• The top of the clamp should touch the arrow located on the
decal on the tube.
• Leave screws and nuts slightly loose.
• Mount the handles to a location that is comfortable
to the user.
• Tighten screws.
CONNECTING THROTTLE CONTROL TO BIKE HANDLE
• Attach throttle control to bike handle.
• Slide wire sleeve over the 2 wires coming from the throttle
and connect wires to mating connecters on wires coming
from engine.
• Slide sleeve to cover all of the exposed wires.
CONNECTING THROTTLE CABLE TO ENGINE
• Run throttle cable under main tube frame and plug it into hole
underneath carburetor.
• Rotate throttle on engine and insert throttle cable.
NOTE:
Throttle cable must be in front of breather tube.
• Squeeze throttle control to check travel of throttle on engine.
SECURING CABLE AND WIRES
• Use 3 wire wraps to secure cable to unit.
• One at the curve of the bike handle.
• One at the main tube near bike handle clamp.
• One at the main tube close to the engine.
THE BRACKET (FIG. 2) MUST BE MOUNTED TO THE
SHIELD WITH THE OPEN SIDE DOWN AS SHOWN. SECURE
THE BRACKET AND SHIELD TO THE GEAR BOX WITH THE 4
SCREWS INCLUDED. THE TOP OF THE BRACKET MUST BE
EVEN WITH THE TOP OF THE SHIELD. TIGHTEN THE
SCREWS FIRMLY WITH A 4mm ALLEN WRENCH.
4
Publicidad
