Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately
prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
section of this manual).
2. Lubricate as shown in the Mainte-
nance section of this manual.
3. Be sure that all nuts, bolts, screws,
and pins are securely fastened.
Inspect moving parts for damage,
breakage
and wear.
Replace if
necessary.
4. Touch up all rusted or chipped paint
surfaces;
sand lightly before painting.
HANDLE
You can fold your lawn mower handle for
storage.
1. Squeeze the bottom ends of the lower
handle toward each other until the
lower handle clears the handle
bracket, then move handle forward.
2. Loosen upper handle mounting
bolts
enough to allow upper handle to be
folded back.
IMPORTANT:
When folding the handle
for storage or transportation,
be sure to
fold the handle as shown or you may
damage the control cables.
• When setting up your handle from the
storage position,
the lower handle will
automatically
lock into the mowing
position.
SQUEEZE
TO FOLD
Operator
control bar
Upper handl
)LD
Lower
FOLD
BACKWARD
Mowing
position
ENGINE
FUELSYSTEM
IMPORTANT:
It is iinportant to prevent
gum deposits from forming
in essential
fuel system parts such as carburetor,
fuel
filter, fuel hose, or tank during storage.
Also, alcohol blended fuels (called
gasohol or using ethanol dr methanol)
can attract moisture which leads to
separation
and formation
of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage.
1. Drain the fuel tank.
2. Start the engine and let it run until the
fuel lines and carburetor
are empty.
• Never use engine or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
° Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during storage.
Add
stabilizer
to gasoline
in fuel tank or
storage container.
Always follow the mix
ratio found on stabilizer container.
Run
engine at least 10 minutes after adding
stabilizer
to allow the stabilizer to reach
the carburetor.
Do not drain the gas tank
and carburetor
if using fuel stabilizer.
ENGINEOIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE" in
the Maintenance
section of this manual).
1s
Publicidad
