Publicidad
Idiomas disponibles
Idiomas disponibles
18
Fig.5
•
Take the components shown in Fig.5;
•
Insert the long pin on the wheel support (Fig. 6);
•
Insert the pin and wheel in the rear right-hand plate of the frame (Figs. 7 and 8);
•
Insert the stop on the pin on the outer side of the frame;
•
Insert the washer on the pin from the inner side of the frame;
•
Assemble the roller system rod on the pin previously installed (Fig. 9) and insert the stop on the
inner side as well;
Fig.9
•
Take the components shown in Fig. 10;
•
Insert the short pin on the wheel support;
•
Insert the pin and wheel in the rear left-hand plate of the frame (Fig. 11);
•
Insert the washer on the pin from the inner side of the frame;
•
Insert the stops on both ends of the pin;
Fig.12
•
Take the steel bar with the two remaining pins and place it close to the frame plates, turning it so
that the black rubber tips face downwards;
•
Insert the right-hand curved rod of the roller system inside the hole on the bar (Fig.12);
•
Insert the pins to block the bar on the armchair frame plates;
•
Insert the stops on both pins (Fig.13);
•
Tip the armchair back into its normal position;
•
Connect the armchair to the mains current and return it to the upright position.
Fig.6
Fig.10
Fig.13
Fig.7
Fig.8
Fig.11
Publicidad
