Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Guide (Continued)
Speakers
Connect the speaker wires. See the wiring diagram (=
page 28) for the proper hookups. Follow the diagram
Carefully to avoid damaging the speakers and the stereo
unit.
The speakers used must be able to handle more than 50
W of audio power. if using an optional audio amplifier,
the speakers should be able to handle the maximum
amplifier output power. Speakers with low input ratings
can be damaged. Speaker impedance should measure
4-8 Q, which is typically marked on most speakers.
Lower or higher impedance speakers will affect output
and can cause both speaker and stereo unit damage.
Battery
Connect the yellow battery lead to the correct radio wire
or to the battery fuse port on the fuse block.
Antenna
Connect the antenna by plugging the antenna lead into
the antenna receptacle.
Equipment
Connect any optional equipment such as an amplifier,
according to the instructions furnished with the
equipment. Leave about 12° (30 cm) of distance
between the speaker leads/amplifier unit and the
antenna/antenna extension cord. Read the operating and
installation instructions of any equipment you will
connect to this unit.
Power
Connect the red power lead to the correct car radio wire
or to the appropriate fuse port on the fuse block.
lf the stereo unit functions properly with all these
connections made, disconnect the wires and proceed to
the final installation.
O Final Installation
Lead Connections
Connect all wires, making sure that each connection is
insulated and secure. Bundle all loose wires and fasten
them with tape so they will not fall down later. Now
insert the stereo unit into the mounting collar.
Congratulations! After making a few final checks, you're
ready to enjoy your new auto stereo system.
"
EN
O Final Checks
. Make sure that all wires are property connected and
insulated.
2. Make sure that the stereo unit is securely held in the
mounting collar.
`
3. Turn on the ignition to check the unit for proper
operation.
If you have difficulties, consult your nearest author-
ized professional installer for assistance.
O Preparation
* We strongly recommend that you wear gloves for
installation work to protect yourself from injuries.
+ When bending the mounting tabs of the mounting
collar with a screwdriver, be careful not to injure
your hands and fingers.
e Disconnect the cable from the negative © battery
terminal (see cautions below).
* Unit should be installed in a horizontal position with
the front end up at a convenient angle, but not more
than 30°.
sue
Less than 30°
SS
Caution: Do not disconnect the battery terminals of
a car with a trip or navigational computer since all
user settings stored in memory will be lost. instead
take extra care with installing the unit to prevent
Shorts.
Dashboard Installation
Instatlation Opening
23/32"
(53 mm)
k— 75/32"
(182 mm)
This unit can be installed in any dashboard having an
opening as shown above. The dashboard should be Ys"
{4.75 mm}-#" (5.56 mm) thick in order to be able to
support the unit.
Publicidad
