Palram Harmony Mythos Hybrid 6x10 Manual Del Usuario página 4

During Assembly
Make sure
the
base
is
square by measuring the diagonals and
level by using
a
spirit
level.
You may
use
silicone lubricant spray
in order to help you slide
the panels into the profiles.
Do
not spray the polycarbonate
panels.
Use a
rubber mallet if
necessary.
All panels
with the stamped words
"THIS SIDE OUT"
must
be
facing out to create
full
UV
protection.
Remove plastic sticker
as
panels are locked
in
place.
Steps 16, 17, 24, 25, 27, 37, 38, 39, 41, 42, 43, 45, 50, 52:
Please Note!
Each
of the
3
greenhouses come with
its
compatible panels kit
as
shown
in
the
content
list and in
the relevant assembly
steps.
When
encountering the information
icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon
indicates
that the installer should
be
inside the product.
This
icon indicates that
the installer should
be
outside the product.
Attention
During assembly
use
a
soft surface below the parts to avoid scratches and damages.
Steps
Step 6:
Part 994, 995 are in
the back of the greenhouse. Attaching them determines the front
side
of
the greenhouse.
Steps 9, 12: The oval hole
in
the crossbars 256 should always
be
assembled to the base
of
the
greenhouse.
Step 10 Door Assembly: Determines door direction.
Part 987
is
the
side
that the door hinges will
be
located. The
door
can be
installed either
as a
left or right hand door.
These
instructions show
a
right
hand
door
assembly.
Window Assembly
Step 34: Decide on the window's location before assembly. Window
can be
installed
in
one of the
indicated options.
Step 50:
In case
the window doesn't closed properly,
please release the screws, adjust the profile
and tighten the
screw.
* Please
tighten
all screws
when completing assembly.
Screws 411 and nuts 412 & 466 are used
thruoghout the assembly
process.
Screws
411
are to be assembled from the outside and nuts 412
&
466
from the inside of
the greenhouse.
Do
not fasten screws and nuts (411,412
&
466) more than 2-3 turns only.
Do
not tighten
them until completion of the panels'assembly, if not specified otherwise.
However, in some steps,
temporary tightening of
a
few
screws may be needed to
prevent
a
profile from falling.
Note: Firmly connect t
e
product to
a
eve surface immediately after completion of the
assembly.
Anchoring this product to the ground
is
essential to
its
stability and rigidity.
It
is
required
to complete this stage
in
order for your warranty to
be
valid.