CR 5034
Place the back of the unit on a stable SURFACE. The bottom of the case should stick out slightly from the
edge of the table. Place the bracket at the bottom of the case. Four holes in the bottom of the case fit
exactly into four holes in the bracket. Screw the bracket on by hand with the four supplied screws. Do not
overtighten the screws!
Make sure the stand is straight and firmly attached to the case.
Now place the unit on its base.
CLEANING
We recommend that you clean the heater at least twice a year to remove accumulated dust and dirt.
- Unplug the appliance from the electrical outlet.
- Wait for the heater to cool down sufficiently.
- You can clean the outside of the heater with a damp cloth or brush. Do not use water or allow water to
enter the appliance. Do not use abrasive detergents or caustic cleaners!
- Do not touch the heater while you are in contact with the water. It is deadly dangerous!
- Clean the air inlet and outlet grills regularly with a vacuum cleaner, using the brush accessory.
STORAGE
- Save the original box in which the heater was packed for storage during the warm months when it is not in
use.
- Clean the heater following the instructions included in the previous section. Pack the heater in its original
box and store it in a cool, dry place.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old
household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old
appliances must be collected separately in order to optimize the recovery and recycling of the materials they
contain, and reduce the impact on human health and the environment. The crossed out "wheeled bin"
symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be
separately collected. Consumers should contact their local authority or retailer for information concerning the correct
disposal of their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2014/35/EU and the requirements of the EMC
directive 2014/30/EU.
15