Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1:
a. Secure the crossbar to the outlet box (not included) with
outlet box screws.
b. Tighten until snug.
NOTE:
The preassembled mounting nipple on the
crossbar should protrude outward.
STEP 2:
a. Remove lock ball from crossbar assembly.
b. Fit backplate of fixture body over the nipple on crossbar
assembly and secure with lock ball.
Note:
The backplate should be snug against the wall and
the lock ball.
?
If not, adjust the length of the nipple on the crossbar
assembly by unscrewing the preassembled hex nuts.
?
Then, screw the nipple in or out of the crossbar until the
desired length is achieved.
?
Once the backplate is secure, remove the lock ball and
backplate and proceed to Step 3.
STEP 3:
a. Connect the
house ground wire
wire
.
b. Connect the
house white wire
supply wire
.
c. Connect the
house black (or red) wire
fixture supply wire
.
d. Wrap each connection with approved electrical tape
and carefully stuff all of the connected wires into the
outlet box.
STEP 4:
a. Re-attach the backplate to the crossbar assembly.
b. Secure with the previously removed lock ball.
STEP 5:
a. Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity. Retain this sheet for future reference.
2015 QuoizelInc.
to the
fixture ground
to the
white fixture
to the
black
3
Outlet Box
Outlet Box
Backplate
Crossbar
Hex Nut and Lock Washer
WHITE OR RIBBED
FROM HOUSE
BLACK (OR RED) WIRE
FROM HOUSE
GROUND WIRE
FROM HOUSE
Backplate
Outlet Box
Crossbar
Crossbar Assembly
Outlet Box Screw
Lock Ball
WHITE OR RIBBED
FROM FIXTURE
BLACK OR SMOOTH
FROM FIXTURE
GROUND WIRE
FROM FIXTURE
Lock Ball
Fixture Body
Nov.2015
Publicidad
