Publicidad
Idiomas disponibles
Idiomas disponibles
Do not overtightan.
Overtighteningcould strip the screw
holes.
Do not operate the cleaner without the
screw in place.
Using
driver,
the screw.
CORD ASSEMBLY
Make sure the quick release cord hook is in
the upright position. Remove the wire tie
from the power cord.
\,
Lock the cord into
place by forcing it
into the locking
notch on the body
of the quick
release cord hook
as shown. This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.
Notch
Power
Quick
Release
Cord
Power
Con
Lower
Cord
Wrap the
power cord
around the
quick release
cord hook
and lower
cord retainer,
then lock the
power cord
plug onto the
power cord.
ATTACHMENT STORAGE
After the handle has been assembled
to the
body and the power cord has been wrapped
around the cord hooks, the attachments
can
be placed in their holders.
1. Snap the suction inlet end of the hose
into the back of the vacuum cleaner.
2. Place the hose behind the handle and
over the hose holder.
3. Place the hose in the front slot of the
tool holder, twisting and pushing
down over
the short hose to assure a good connection.
4. Place the extension wand in the rear slot
of the tool holder.
5. Slide the crevice tool into the slot beside
the wand.
6. Place the dusting brush or combination
brush on the wand with the brush portion
up.
Handle -
Brush
Extension
Wand
Suction
Inlet
Tool
Holder
Tool
Publicidad
