Publicidad
Idiomas disponibles
Idiomas disponibles
CONDITION/REASON:
ADJUSTMENT:
REFRIGERATOR too warm
REFRIGERATOR Control
one setting higher
FREEZERtoo warm/too
little ice
FREEZER Control one
setting higher
REFRIGERATOR too cold
REFRIGERATOR Control
one setting lower
FREEZERtoo cold
FREEZER Control one
setting lower
Additional
Features
Rapid Cool (on some models)
The Rapid Cool feature assists with periods of high refrigerator
use, full grocery loads or temporarily
warm room temperatures.
•
Press RAPID COOL to set the freezer and refrigerator
to the
coldest temperature
settings.
NOTE: The Rapid Cool light will be illuminated
when Rapid
Cool is selected. If you try to adjust the temperature
when
Rapid Cool is on, the Rapid Cool icon will blink three times
and then turn off.
Press RAPID COOL again to return to the selected
temperature
set point.
NOTE: The Rapid Cool feature will automatically
shut off in
approximately
24 hours.
Filters Reset (on some models)
The Filters Reset control allows you to restart the filter status
tracking feature each time you replace the air filter or water
filter.
•
Press and hold FILTERS RESETfor 3 seconds. The filter icons
will turn off. See "Install Air Filter" and "Water
Filtration
System."
ce are
IMPORTANT: For models with a water filter, after connecting the
refrigerator
to a water source or replacing the water filter, fill
and discard three full containers of ice to prepare the water
filter for use.
Tumincj the Ice Maker
On/Off
To turn the ice maker ON, simply lower the wire shutoff arm.
To manually turn the ice maker OFF, lift the wire shutoff arm to
the OFF (arm up) position and listen for the click.
NOTE: Your ice maker has an automatic
shutoff. As ice is made,
the ice cubes will fill the ice storage bin and the ice cubes will
raise the wire shutoff arm to the OFF (arm up) position. Do not
force the wire shutoff arm up or down.
Ice Storage Bin
.
2.
.
Wash the ice storage bin with mild soap and warm water.
Slide the ice storage bin under the ice maker, and push it
toward the back as far as it will go.
Lower the arm on the ice maker to the "on" position.
NOTE: It usually takes approximately
24 hours for the ice
maker to begin producing ice. You may notice the ice has an
"off-taste." If so, discard the first three batches of ice
produced.
After that the "off-taste" should be gone.
Ice Production Rate
The ice maker should produce approximately
8 to
12 batches of ice in a 24-hour
period. Allow 3 days to
completely
fill the ice container.
To increase ice production,
lower the freezer and
refrigerator
temperature.
See "Using the Control(s)." Wait
24 hours between adjustments.
Remember
The quality of your ice will be only as good as the quality of
the water supplied to your ice maker. Avoid connecting the
ice maker to a softened water supply. Water
softener
chemicals (such as salt) can damage
parts of the ice maker
and lead to poor quality ice. If a softened water supply
cannot be avoided, make sure the water softener is
operating
properly and is well maintained.
Do not use anything sharp to break up the ice in the bin. This
can cause damage
to the ice storage bin and the dispenser
mechanism.
Do not store anything on top of or in the ice maker or ice
storage bin.
15
Publicidad
