Aqua Medic LEDspot 200 W Manual De Instrucciones página 7

In purchasing this LEDspot, you have selected a top quality product. It has been specifically designed for
aquarium use and has been tested by experts. High quality components and latest technology as well as modern
design guarantee for enjoying your aquarium lighting for many years.
1. Technical Data
Line voltage: 100 - 240 Volt, 50/60 Hz (if not stated otherwise on the ID-label).
Lamps: 100 W resp. 200 W LED chips (12,000 Kelvin or 6,500 Kelvin, other light colours on request), 120/200
W flex, bundled to 90° (60° lens available as accessory).
The electronic ballast is placed in a splash-proofed body on the light. The cooling element is made of saltwater-
resistant anodized aluminium. The cooling is done passively. Diametre: 32 cm. Height: 100 W = 38 cm, 200 W
= 48 cm. The spotlight can be hung up with a chain or screwed on with the holder.
2. Unpacking
On unpacking, please check the light immediately for any damages. In case of any complaints, please contact
your dealer directly.
Included in shipment:
LEDspot with holder and central loop for hanging up with chain
•
Cable link for power supply and control cable
•
3. Safety advices
The light cannot be used as aquarium cover. It has to be mounted only above the aquarium. If it is mounted
•
above the aquarium, the minimum distance between lighting and aquarium must be at least 30 cm.
The housing may become hot during operation. Be cautious when touching it! For cleaning, disconnect
•
the light from the mains and let it cool down. Afterwards, take the light down.
When cleaning, take care that no humidity enters the interior of the light!
•
Pay attention to a sufficient thermal exchange. Keep the ventilation slits always free! Do not mount
•
the system in enclosures or behind panels. Missing aeration may result in overheating and damage the
electrical components.
Do not try to repair the light (LEDs, electronic parts). Please send it in for checking, preferably with a list of
•
defects. Also, broken LED chips can only be exchanged by an expert.
When working on the light, always pull all power plugs.
•
4. Installation
The light can be hung up on the central loop with a chain on the ceiling or can be screwed on with the holder.
5. Changing the lenses / lamps
LEDspot 100/120 W:
Broken LED chips can only be exchanged by an expert. The standard built-in 90° lens can be subsequently
replaced by a lens with 60°. For this, place the lamp steadily with the LED upward (Fig. 1) and remove the four
screws with a 3 mm Allen screw (Fig. 2). Now, the retaining ring (Fig. 2, No. 6) and the lens (Fig. 3, No. 5) with
the silicone holder (Fig. 3, No. 4) can be removed, the lens can be exchanged (convert the silicone holder) and
then the whole spot can be remounted. Please respect the sequence: flat sealing, passe-partout, aluminium
retaining ring, lens with silicone holder, retaining ring.
Available spare parts: Please refer to www.aqua-medic.de.
7
All manuals and user guides at all-guides.com
Operation manual ENG