Descargar Imprimir esta página

SNOWJOE sunjoe 24V-PS8-LTE Manual Del Operador página 10

Motosierra inalámbrica de altura 24 v máx | 2.0 ah | 20.3 cm | multi-ángulo

Publicidad

Idiomas disponibles

Idiomas disponibles

Charging the Battery
1. Push the push lock button on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
Fig. 1
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
Fig. 2
3. The battery will take approximately 1 hr 20 minutes
to charge. The battery indicator LEDs will twinkle and
illuminate one by one during the charging process.
Unplug the charger immediately when the 3 LEDs are all
illuminated.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery
m
WARNING!
This charger does not automatically
turn off when the battery is fully charged. Please take care
not to leave the battery plugged into the charger. Switch
off or unplug the charger at the mains when charging is
complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
R
Push button
Battery
indicators
10
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
m
DANGER!
Never start the motor before installing the
guide bar, chain, and chain/sprocket end cover. Without all
these parts in place, the clutch can fly off or explode, exposing
the user to potentially serious injuries.
Installing/Replacing Guide Bar +
Cutting Chain
Tools and supplies required:
• Hex key wrench (provided)
• Heavy-duty work gloves
NOTE: When replacing the guide bar and chain, use only
identical replacement parts. Make sure the pole chain saw
is disconnected with the battery before proceeding with
installation.
1. Remove the hex bolt by screwing it counterclockwise with
the hex key wrench (Fig. 3).
Fig. 3
Chain/sprocket
end cover
2. Screw the chain/sprocket end cover knob
counterclockwise to release chain/sprocket end cover
(Figs. 4 – 5).
Fig. 4
Chain/sprocket
end cover
Hex key wrench
Hex bolt
R
Chain/sprocket
end cover knob

Publicidad

loading