Greencut MP500C Manual De Instrucciones página 50

50
PRODUCT USE
MODE SELECTION
There are 3 modes: hammering, rotation and hammering and just rotation.
To switch between modes turn the mode selector lever while pressing the lock push button. Adjust the position of the
arrow in the direction of the mode you want to use.
To lock, release the lock pushbutton and make sure it is not in an intermediate position.
SPEED ADJUSTMENT
The rotational speed of the drill can be controlled by varying the amount of force with which the trigger switch is
squeezed. There is low speed when the trigger is pulled lightly and increases when pressure is intensified. To stop the
rotation movement release the trigger to its original position.
ROTATION AND HAMMERING
1. Press the lock button and turn the mode selector to position .
2. Mount the drill bit.
3. Rotate the head and confirm that the drill bit has engaged correctly.
4. Tighten the trigger switch and press lightly to gradually release the powder
from the drill bit.
ROTATION
1. Press the lock button and turn the mode selector to the position
ATTENTION: Do not attempt to drill anchor or concrete holes in rotation-only mode.
HAMMERING
1. Press the lock button and turn the mode selector to position
2. Mount a chisel on the drill chuck. In the mode
position.
3. Turn the lock button to the position
Level change
to lock the tool.
1
Lock button
.
.
you can rotate the chisel and adjust it to the desired
3
Lock
button
Mode Selector