Costway NP10749 Instrucciones De Montaje página 6

8. Plug the blower into an approved grounded outlet.
9. Keep the blower(air pump) and power cord away from water and
moisture.If water contacts the blower(air pump), unplug the blower(air
pump) power cord. Do not operate until the blower is completely dry.
10. Ensure the blower(air pump) is free from debris and securely sited to
avoid tripping. To inflate the bouncer unit,(press the reset button on GFCI)
turn the blower (air pump) "on/off" switch to on. The continual air-flow
blower (air pump) must be left on at all times while the Bouncer is being
used. (Refer to picture 2)
11. If the product comes with water bags, please follow the
undermentioned instruction, otherwise, overleap this point. Spread out
the product, place and fasten the empty water bags at the two sides of
the product. Open the stopple and fill water in the water bags until 80%
full (about 22kg), push and close the stopple.Make sure water bags are
firmly attached on the product and no water leakage before the product is
fully inflated, and never allow children to play on the side without installing
water bags. (Refer to picture 3)
12. The Bouncer should take less than 2 minutes to inflate.
13. If the product comes with slide extension, please follow the
undermentioned instruction, otherwise, overleap this point. Add the Slide
extension to the end of the Slide using the hook and loop fastener. (Refer
to picture 4)
14. Ground support stakes are used for lawn ground surfaces.Hook
stakes over loops in the Bouncer. To prevent overturn or lift during play,
push stakes firmly into the soil. The stakes should be placed level with or
under the ground in order to reduce tripping hazards. (Refer to picture 5)
15. To prevent overturning during play, periodically check that the ground
stakes are securely in place. To anchor the product properly,ALWAYS
anchor the product and blower with corresponding ground stakes before
use.
10
16. Make sure the Bouncer is inflated fully and securely anchored before
children enter to play.
17. Failure to do so will result in the product being unstable and can
cause serious injuries. Use of this product when under-inflated or during
deflation could cause serious injuries.
18. Always check for excessive air loss, and re-inflate before allowing
play to continue. As the product remains inflated through constant air
flow, air leakage from the seams is normal and necessary so the product
does not over inflate.
Disassembly Instructions
1. Make sure all children exit the Bouncer.
2. Make sure the Bouncer is free of foreign abjects.
3. Turn the blower (air pump) "on/off" switch to off.
4. Unplug the blower (air pump) power cord.
5. Loosen string and detach the air fill tube from the blower.
6. Remove ground support stakes and plastic balls.
7. Let the Bouncer deflate entirely. It should deflate on its own within 5
minutes. (Refer to picture A)
8. Fold it in half, and then fold it in half 2 more times, parallel to the first
fold.(Refer to picture B and C)
9. Roll it up tightly from the end opposite the air fill tube.(Refer to picture
D and E)
10. Slip carry bag over the rolled-up Bouncer and plastic balls.(Refer to
picture F)
11. Flip the bag and the Bouncer over, close the bag zipper. (Refer to
picture G)
12. Store the Bouncer and the Blower in a dry place for future use.
13. Never leave either the Bouncer or the Blower outside in the rain when
product is not in use.
11