Defiant 17000075 Guía Para El Uso Y Cuidado página 6

Installation (continued)
2
Wiring the light fixture
□
Wire the light fixture using the included wire
connectors.
Note: All wiring must be run in accordance with the
National Electrical Code through conduit or another
acceptable means. Contact a qualified electrician
if there is any question as to the suitability of the
system.
□
Route the light fixture wires through the large
holes in the gasket (AA).
□
Connect the light fixture wires to the junction
box wires with wire connectors (BB).
□
Connect black to black
□
Connect white to white
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
3
Mounting the light fixture
□
Make sure wire connectors and wires are inside
the junction box.
□
Secure the canopy to the junction box using
the mounting screws (CC) and canopy rubber
washer (EE) that best fit the junction box. Do not
overtighten.
□
Caulk around the canopy and mounting surface
with silicone sealant.
4
Installing flood lamps
□
Adjust the lamp holders by loosening the lock
nuts but do not rotate the lamp holders more
than 180° from the factory setting. When
screwing in the floodlamps, do not overtighten.
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
EE
CC
6
BB
AA