Publicidad
Idiomas disponibles
Idiomas disponibles
WL 1000 18.0
Operating instructions
Before switching on the power
tool
Unpack the power tool and accessories and
check that no parts are missing or damaged.
NOTE
The batteries are not fully charged on delivery.
Prior to initial operation, charge the batteries
fully. Refer to the charger operating manual.
Inserting/replacing the battery
■ Press the charged battery into the power
tool until it clicks into place (see figure B).
■ To remove, press the release button (1.) and
pull out the battery (2.) (see figure C).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!
Removable belt clip (see figure D)
■ To install, align the belt clip 8 with the tool.
Insert and tighten the screw.
■ To remove, loosen and remove the screw
and the belt clip 8.
Hook (see figure E & F)
The hook 1 can be pulled out and pivoted
360 degrees to hang the light on a hook-like
object.
To prevent the risk of injury or product
damage, make sure that the hook-like object
is sturdy enough to support the weight of the
light with attached battery pack.
Magnet bar (see figure G)
WARNING!
Keep the inspection light away from cardiac
pacemakers. The magnets generate a field that
can impair the function of cardiac pacemakers.
CAUTION!
Keep the inspection light away from magnetic
data medium and magnetically sensitive
equipment. The effect of the magnets can
lead to irreversible data loss.
The light is equipped with two pairs of
magnet bars 7 which could be used to
temporarily mount the light on any surfaces
(e.g., steel, iron) with magnetic force.
NOTE
To prevent the risk of injury or product
damage, make sure that the surface you are
going to mount the light on is having enough
magnetic force to hold the combined weight
of the light and attached battery pack.
Articulating the light head (see
figure H)
The head pivots 180° and swivels 270° for
maximum flexibility. Manually move the head
to any position within the rotating range. Do
not force the head beyond that range.
Brightness adjustment
(see figure I)
The inspection light is equipped with a
three-stage brightness adjustment button,
providing different light intensities for your
operation.
Press the on/off button 6 briefly to cycle
through the three-stage brightness. Each
press of the button switches brightness to the
next stage.
■ To turn the light ON, press the ON/OFF
button. The light will be turned on at
maximum brightness.
■ To switch to medium brightness, press the
ON/OFF button again.
■ To switch to low brightness, press the ON/
OFF button again.
■ To turn the light OFF, press the ON/OFF
button again (a fourth time).
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, remove the battery pack from the
tool.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
11
Publicidad
