Rated capacity for cooling
Rated capacity for heating
Rated power input for cooling
Rated power input for heating
Rated energy efficiency ratio
Rated coefficient of performance
Power consumption in thermostat-off mode
Power consumption in standby mode
Electricity consumption of double duct appliances
(indicate for cooling and heating separately)
Electricity consumption of single duct appliances
(for cooling)
Electricity consumption of single duct appliances
(for heating)
Sound power level
Global warming potential
Tones of CO
equivalent
2
N/A - Not applicable.
Troubleshooting
If a condition listed below occurs, please check the following items before calling customer service.
Problem
1. Unit does not start when
pressing on/off button
2. Not cool enough
3. Noisy
4. The water full indicator lights
up frequently just 1 or 2 hours
after last time water drainage.
5063022060242_MNL_IN_V04.indd 14
5063022060242_MNL_IN_V04.indd 14
P
rated
P
rated
P
EER
P
COP
EERd
COPd
P
TO
P
SB
DD:QDD
SD:QSD
SD:QSD
LWA
GWP
Possible Cause
Water full indicator lamp blinks, and
water tank is full.
Room temperature is lower than the
setting temperature (Cooling mode).
The doors or windows are not
closed.
There are heat sources inside the
room.
Exhaust air hose is not connected
or blocked.
Temperature setting is too high.
Air inlet is blocked.
The ground is not level or not flat
enough.
The sound comes from the flowing
of the refrigerant inside the air
conditioner.
Water splash motor is damaged.
14
Symbol
Value
for cooling
3.5
for heating
2.638
1.346
1.147
2.6
2.3
N/A
0.5
N/A
1.346
1.147
65
3
0.000678
Solution
Dump the water out of the water
tank.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if
possible.
Connect or clean the exhaust air
hose.
Reset the temperature.
Clean the air inlet.
Place the unit on a flat, level
ground if possible.
It is normal.
Repair or replace.
Unit
kW
kW
kW
kW
-
-
W
W
kWh/h
kWh/h
kWh/h
dB(A)
kgCO
eq.
2
t
12-12-2022 16:08:06
12-12-2022 16:08:06