Publicidad
Idiomas disponibles
Idiomas disponibles
TIME LOCK COUNTDOWN
Preparing your Time Lock Safe
1. Open the safe with the keys provided.
Remove the emergency lock cover (panel cover), insert the emergency key,
turn to a quarter anticlockwise, keep it turned, and turn the knob clockwise to
open the door.
2. Insert the batteries in the safe slot (internal panel).
3. Reset the safe code by pressing the button inside the battery slot, dial the
new code on the keypad outside (3 to 8 numbers), and confirm it by pressing #.
Setting up the timer
4. Press the round button to activate the timer.
5. Turn anticlockwise to disable the sound.
6. Press the knob again to set up the timer.
7. Turn clockwise to set up the countdown.
8. Rotate the knob to increase or decrease the day (DD).
9. Push the knob to move to the hour (HR) and minute (MN).
10. The countdown will start after 20 seconds from your last digitation or if
you keep the knob pressed for 2 seconds.
11. At the end of the countdown, it will be possible to open the safe by dialing
the correct code, followed by the letter #.
2
SAFE
Key Entry
The key will work anytime, regardless of the status of the time lock. This is by
design to allow access should the need arise.
Do not lock the keys inside the safe; give them to a relative or a friend; you will
need them if the batteries of the safe run low or if you mis-program the safe.
General Information
Replace the batteries once a year.
You can receive video call assistance to set up the safe using WhatsApp,
Skype, Messenger, or Google Duo... write me at:
info@geniehand.com
Geniehand.com
CAUTION:
The user pre-set code is "159#" .
Three continuously wrong entries will activate the warning beep for 20
seconds.
Another three continuously wrong entries will activate the warning beep for 5
minutes. You can only stop the beeps by opening the safe with an emergency
key and power-cut by removing the battery.
Publicidad
