Publicidad
Idiomas disponibles
Idiomas disponibles
You can change gears by turning the speed shift button
, as it is shown on the pictures
speed gear has a special mechanism that enables
changing the number of revolutions when the mixer does
not operate or when it is stopping. If you turn the speed
shift button at full speed, the elements in the gear housing
can break down.
Operation of electronics
The power tool is equipped with electronics that has the
following functions:
Overload protection: There is a MAJOR reduction
in load speed. The motor temperature is too high!
Allow the machine to run at idle speed until it has
cooled down.
Overload protection: There is a SLIGHT reduction
in load speed. The machine is overloaded. Reduce
the load before continuing to work.
Restart protection: The machine does not start. The
restart protection is active. If the mains plug is inserted
with the machine switched on, or if the power supply is
restored following an interruption, the machine does
not start up. Switch the machine off and on again.
Putting down the mixer
The mixer is designed for easy, safe and reliable use.
Put down the mixer resting on the protection frame and
the stirrer paddle.
We do not recommend leaning the mixer to the wall for it
can easily fall and be damaged.
MAINTENANCE AND SERVICING
Always disconnect the plug from power
source before making any adjustments
on the power tool!
Maintenance and care
!
Your tool does not need any special care, though in
time you should check the parts that will wear out under
normal working conditions. This includes checking and
replacing shut-off graphite brushes and the lubricant in
the reducing gearbox. We suggest that you contact our
authorized Service Centers.
!
Make sure that the mixer and especially the
ventilation inputs/outputsand the mains cable are
always clean.
Servicing
!
In case of electric or mechanical damage take the
power tool to one of the officially registered Perles
Service Centers. Each individual tampering with the
tool can be dangerous.
!
Repair
in
unauthorized
performed at your own risk.
!
If the replacement of the supply cord is necessary,
this has to be done by Perles or an authorized
Perles service agent in order to avoid a safety
hazard
Service drawings spare parts information and addresses
of Service Centers are also available on: www.perles.com
and
. The
service
centers
are
12
GENERAL INFORMATION ABOUT
GUARANTEE
Guarantee is offered according to legal provisions that are
valid in individual countries.
Guarantee does not cover:
- Regular maintenance,
- Wear-and-tear materials (change of carbon brushes,
grease, etc.),
- Enclosed accessories,
- Damages caused by inappropriate use,
- Damages caused by not using original accessories,
- Damages due to normal wear, and
- Damages caused by overloading.
If any repairs are required, take the tool to the nearest
authorized service centre. Do not dissemble the tool by
yourself!
Guarantee terms and the list of service centres are written
on the guarantee card.
WASTE DISPOSAL AND
ENVIRONMENT PROTECTION
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
!
Do not dispose of power tools into
household waste
Only for EC countries:
According the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be
collected separately and disposed of in an
environmentally correct manner
Subject to change without notice.
!
Publicidad
