Descargar Imprimir esta página

Sears Kenmore ULTRA WASH 665.1327 Serie Manual De Uso Y Cuidado página 90

Ocultar thumbs Ver también para Kenmore ULTRA WASH 665.1327 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Filter Removal
Instructions
I.
Turn the Upper Filter Assembly 1/4 turn counterclockwise
and lift out.
2. Grasp the Lower Filter in the circular opening, lift slightly, and pull forward
to remove.
3. Clean the filters as shown below.
Locating tab
Cleaning Instructions
IMPORTANT:
Do not use wire
brush, scouring
pad,
etc., as they
may damage
the filters.
Rinse filter
under
running
water
until most soils are removed.
If you
have
hard-to-remove
soils or calcium
deposits
from
hard water,
a
soft brush
may be required.
To remove
Upper
Filter
Assembly
Filter Reinstallation Instructions
1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the
bottom of the dishwasher so the round opening for the Upper Filter Assembly lines up with
the round opening in the bottom of the tub.
2. Insert the Upper Filter Assembly into the circular opening in the Lower Filter.
3. Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter
is locked into place. If the filter is not fully seated (still turns freely), continue to turn the
filter clockwise until it drops and locks into place.
NOTE: The Upper Filter Assembly arrow does not have to align with the arrow in the
Lower Filter as long as the filter is locked.
g tab
To replace
Upper Filter Assembly
IMPORTANT:
To avoid
damage
to dishwasher,
do not operate
your dishwasher
without
the ULTRA WASH _HEfilters
properly
installed.
Be sure the Lower
Filter is securely
in place
and the Upper
Filter Assembly
is locked
into place.
If the Upper
Filter
Assembly
turns
freely,
it is not locked
into place.
DISHWASHER EFFICIENCY TIPS
Hot water
dissolves
and activates
the dishwasher
detergent.
Hot water
also dissolves
grease
on dishes and helps glasses dry spot-
free.
For best dishwashing
results, water
should
be 120°F (49°C)
as it enters the dishwasher.
Loads
may
not wash as well if the water
temperature
is too low.
Additional
efficiency tips
To save water,
energy and time, only scrape
dishes. Do not rinse dishes before
putting
them into the dishwasher.
Use a delay
feature
to run your
dishwasher
during
off-peak
hours.
Local utility
providers
recommend
avoiding
heavy
usage of
energy
at certain
times of day.
During
the summer,
run your dishwasher
at night. This reduces
daytime
heat
buildup
in the kitchen.
Use a rinse aid to improve
drying.
10

Publicidad

loading