Qlima SRE3230C-2 Instrucciones De Uso página 116

F
empty full
C
G
H
I
D
J
4
116
remove the pump. Carefully reposition the fuel cap back on the tank. Clean
off any spilled fuel.
7 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
• Do not move the heater after reinstalling the tank.
• Take care not to damage the cap while filling the tank. Deformation of the cap
can lead to fuel leakage.
8 Turn the heater on again.
SETTING THE TIME
Set the time to use the heater as a clock or if using the timer. You can even set
the time when the heater is on.
1 Press the mode key R to set the time (fig. G). Time set and the time flash on
the display.
2 Press the buttons () or ()
to 23:59. Press the () button to go forwards and the () button to go backwards.
The time will change in one minute steps each time you press one of these 2
buttons. The time on the display will change in ten minute steps if you keep the
button pressed (fig. H.).
3 Press the mode key R again to activate the timer function. See chapter F.
4 Press the mode key R to display the time (fig. I.). If the time is not set, the
display indicates --:--.
The time must be set again after a power cut or if the plug has been removed
from the socket.
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the ON / OFF button
cigarette lighter.
1 Press the ON / OFF button
The ignition indicator will light up: the required temperature and the ambient
temperature are displayed (fig. J.). The ambient temperature is displayed from
1ºC. If the temperature is below 0ºC, Lo is displayed. Ignition takes about 45
seconds.
2
Normal combustion:
• The flames are blue
• The burner grille can become red
to set the time. The time displays the numbers 00:00
19 19
. Never use matches or a
20 20
.
20 20