Publicidad
Idiomas disponibles
Idiomas disponibles
V!IkVlrl__l;l _11_[€!
1.
DO NOT assemble the Dust Collector until you are
sure the tool IS NOT plugged in.
2.
DO NOT assemble the Dust Collector until you are
sure the power switch is in the "OFF" position.
2,
For your own safety, DO NOT connect the machine
to the power source until the machine is completely
assembled and you read and understand the entire
Owner's Manual.
CASTER
TO BASE ASSEMBLY
Fig. 7
B
@
A
MOUNT
HOUSING
ASSEMBLY
V!YAv/"-I-'I#11_, [_1
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED
FROM THE POWER SOURCE.
Refer to Figure 8
Housing assembly is mounted to the supports. To mount
housing assembly:
1. Lay base and supports assembly (long side) on a flat
surface.
2. Lay blower housing assembly (long side) on flat surface
with bottom (non-motor) side facing supports.
3. Slide blower housing assembly between supports until
holes in supports and housing are aligned.
4. At support nearest large opening in blower housing, se-
cure hanger bracket and support to blower housing
using hex bolts and lock washers.
5. Secure remaining support on that side using hex bolts
and lock washers.
6. Carefully flip partially completed assembly over and se-
cure remaining two supports to opposite side of blower
housing using hex bolts and lock washers.
7. Secure dual inlet to bottom of blower (below motor)
using Phillips head screws.
8. Attach open ring of inlet cap to one of the dual inlets.
9. Carefully lift complete assembly upright onto the casters.
1,
Insert threaded rod of caster (A) into the hole
located on the underside of base (B) and fasten
with 3/8" lock-washer (C) and 3/8-16 hex nut (D).
See figure 7.
2.
Assemble the remaining three casters to the under-
side of the base in the same manner.
MOUNT
SUPPORTS
V!_l, V iv/,3 ;1_, i i#[dl
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED
FROM THE POWER SOURCE.
Refer to Figure 8
Supports are mounted onto top of the base. To mount
supports:
1. Lay the base on the casters.
2. Position one support above the base so that the two
holes on the supports are aligned with two holes at the
corner of the base.
3. Secure support to base using two hex bolts and lock
washers.
4. Repeat steps 1 through 3 to mount other supports to
remaining corners of base.
Figure 8 -
Lock Washer
Hanger
/
Blower
Housing j_
Assemblyf _
Screw
',_
Dual
_,
Inlet
Inlet Cap
Bolt
_ock
Washer
Bolt
\
Support
Bolt
Washer
iI
Mounting Supports,
Housing Assembly,
Dual Inlet and Inlet Cap
11
Publicidad
