Publicidad
Idiomas disponibles
Idiomas disponibles
ALLURE
TM
WS1 SERIES
NuTone
° .o .ooo
Page 3
PREPARE THE HOOD
PREPARE THE HOOD
El
Remove
AIR CHUTE
Damper/Duct
Connector
from
inside the hood.
Set connec-
tor aside - with
mounting screws
and parts bag.
El
DAMPER/DUCT
CONNECTOR
Remove Wir=
Cover from
inside the hood.
Set cover and
mounting screw
aside.
53
Remove Air
Chute-
held in
place with one
(1) screw.
NOTE: Be care-
ful not to discon-
nect any wires.
El
Remove Baffle
from air chute.
WIRING
COVER
Remove either
top or back wir-
ing knockout and
install approved
Electrical
Cable
Clamp_.
ELECTRICAL
CABLE CLAMP
Non-Ducted
installation
- Skip to "Connect
Wiring"section.
The following
Steps (6 thru
13) are for
_!iiii;
DUCTED
INSTALLATION
ONLY.
(3) #8 SCREWS
LIGHT
PANEL
BAFFLE
Rotate baffle. Re-
insert baffle into air
chute (as shown) so
that baffle tabs fit all
the way into slots in
air chute. An audible
"click" will be heard
when fully installed.
This will close off
the air flow through
the non-ducted slots
on top of hood.
SLOTS
BAFFLE
\
TABS
El
Remove L_ght Panel - held in place with (3) #8 screws
and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between _ort
fin and light panel.
SUPPORT FIN
Publicidad
