Descargar Imprimir esta página

Thermador An American Icon HPWB30 Manual Del Usuario página 4

Ocultar thumbs Ver también para An American Icon HPWB30:

Publicidad

Idiomas disponibles

Idiomas disponibles

ha
IMPORTANT SAFETY INSTRUCTIONS
Read All Instructions Before Using the Appliance.
READ AND SAVE THESE INSTRUCTIONS
Electrical requirements
IMPORTANT
Observe
all governing codes and ordinances.
It is the customer's
responsibility:
To contact a qualified electrical installer.
To assure
thatthe electrical installation is adequate
and in conformance
with National
Electrical
Code,
ANSI/NFPA
70 — latest
edition*, or CSA
Standards
C22.1-94,
Canadian
Electrical
Code,
Part
1 and
C22.2
No.0-M91
- latest edition** and all local
codes and ordinances.
If codes
permit and a separate
ground wire is used,
itis recommended
thata qualified electrician
determine that the ground path is adequate.
Do not ground to a gas pipe.
Check
witha qualified electrician if you are not sure
range hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
IMPORTANT
Save
Installation Instructions for electrical
inspector's
use.
The range hood must be connected with copper
wire only.
The range hood should be connected directly to the
fused disconnect
(or circuit breaker)
box through
metal electrical conduit.
Wire sizes must conform to the requirements of the
National Electrical
Code
ANSI/NFPA 70—latest
edition*, or CSA
Standards
C22.1-94,
Canadian
Electrical
Code
Part 1 and C22.2
No. 0-M91
- latest
edition** and all local codes and ordinances.
A ULL.- or C.S.A.- listed conduit connector must be
provided at each end of the power supply conduit
(at the range
hood and at the junction box).
Copies
of the standards
listed may be obtained from:
* National Fire
Protection
Association
Batterymarch
Park
Quincy,
Massachusetts
02269
** CSA
International
8501
East
Pleasant
Valley
Road
Cleveland,
Ohio 44131-5575

Publicidad

loading