Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART
PROBLEM
CAUSE
L.oss of power
I.
Rear of lawn mower
Poor cut -
1.
Llneven
2.
3.
Excessive
1.
vibration
2.
Starter rope hard
1.
_opull
2.
3.
4.
3rass
catcher
1.
_ot filling (if so
2.
.=quipped)
3.
_lard to push
1.
2.
3.
4,
housingor cutting blade
dragging
in heavy grass.
2. Cutting
too much grass.
3. Dirty air filter.
4. Buildup
of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking
speed too fast.
Worn, bent or loose blade.
Wheel
heights
uneven.
Buildup
of grass,
leaves
and trash under mower.
Worn, bent or loose blade.
Bent engine crankshaft.
Engine
flywheel
brake is on
when control
bar is releasec
Bent engine crankshaft.
Blade
adapter
broken.
Blade dragging
in grass.
Cutting
height too low.
Lift on blade worn off.
Catcher
not venting air.
Grass is too high or wheel
height is too low.
Rear of lawn mower
housing
or blade
dragging
in grass.
Grass catcher
too full.
Handle
height
position
not
right for you.
CORRECTION
1. Set to =Higher Cut"
position.
2.
Set to "Higher
Cut"
position.
3.
Clean/replace
air filter.
4.
Clean underside
of mower
housing.
5.
Check oil level.
6.
Cut at slower walking
speed.
1. Replace
blade. "lighten
blade
bolt.
2.
Set all wheels at same
height
3.
Clean
underside
of
mower
housing.
1. Replace blade. "nghten
blade bolt.
2. Contact a Sears or other
qualified service center.
1. Depress
control
bar to
upper handle
before
pulling
starter
rope.
2.
Contact a Sears or other
qualified service center.
3.
Replace
blade adapter.
4.
Move lawn mower to cut
grass or to hard surface.
1. Raise cutting height.
2.
Replace
blade.
3.
Clean grass catcher.
1. Raise cutting height.
2.
Raise rear of lawn mower
housing
one (1) setting
higher.
3.
Empty grass catcher.
4. Adjust
handle
height to
suit.
17
Publicidad
