Toro eTimeCutter eMR4275 Manual Del Operador página 69

Primary Controller Faults (continued)
Code
80-XXX-08
80-XXX-10
80-XXX-11
80-XXX-12
80-XXX-19
80-XXX-26
80-XXX-27
80-XXX-28
80-XXX-29
80-XXX-30
80-XXX-31
Traction/Blade Motor Controller Faults
Code
81-XXX-00
82-XXX-00
83-XXX-00
84-XXX-00
85-XXX-00
81-XXX-01
82-XXX-01
83-XXX-01
84-XXX-01
85-XXX-01
81-XXX-02
3445-793A
Fault Description
A fault occurred in the right motion-
control sensor.
There is no CAN signal for the blade
controller (refer to the serial number to
identify location).
There is no CAN signal for the blade
controller (refer to the serial number to
identify location).
There is an issue with the firmware
version compatibility.
A fault occurred in the DC-DC power
converter.
There is no CAN signal for the blade
controller (refer to the serial number to
identify location).
There is a microcontroller unit (MCU)
hardware error.
There is an MCU flash data validation
error.
There is an MCU non-maskable
interrupt error.
There is an MCU error.
There is a voltage reference error.
Fault Description
There is a hall signal error.
The hall signal sequence is abnormal.
The controller started abnormally.
Page 7–7
Corrective Action
Check for loose connections; if issues
persist, contact an Authorized Service
Dealer.
Check for loose connections; if issues
persist, contact an Authorized Service
Dealer.
Check for loose connections; if issues
persist, contact an Authorized Service
Dealer.
Contact an Authorized Service Dealer
for a software update.
Contact an Authorized Service Dealer.
Check for loose connections; if issues
persist, contact an Authorized Service
Dealer.
Contact an Authorized Service Dealer.
Contact an Authorized Service Dealer.
Contact an Authorized Service Dealer.
Contact an Authorized Service Dealer.
Contact an Authorized Service Dealer.
Corrective Action
Contact an Authorized Service Dealer.
Contact an Authorized Service Dealer.
Contact an Authorized Service Dealer.
Troubleshooting: Display Error and Fault Code
Troubleshooting