mspa Alpine D-AL06 Manual Del Usuario Y Tarjeta De Garantía página 13

NOTE: Deflation Instruction
Spa Deflation
1. Unscrew the manometer cap on the spa pool to deflate the spa.
2. Once the deflation is completed, replace the cap back.
Water Filling
4.
4.1 Check the spa liner is at the selected area and point
the drain valve toward a suitable draining area before
inflation.
4.2 Fill the spa tub with fresh water to a level between
Minimum and Maximum line marked on the
inside of the spa wall.
Do not over fill the spa. It is recommended to fill the spa with lukewarm water for quick heating and
energy saving.
WARNING:
● Water level must reach the Minimum water line but not exceed the Maximum line to avoid
pump failure.
● Never pour water with a temperature higher than 40°C(104°F) into the spa directly.
● To avoid control system failure, do not operate the spa until water reaches the Minimum
line.
4.3 After water filling, double check the spa pool air pressure to make sure the manometer points out the
Green section.
4.4 Place the zipper spa cover over the spa tub, and make sure the spa cover zipper are closed and lock
the cover by the digital lock in the accessory pack.
IMPORTANT:
● Inspect the spa pressure regularly for leak, premature wear or deterioration.
● Check and wax the zipper regularly, to make it smooth for operation and avoid splits.
Note:
Check before inflation whether the manometer cap is
screwed up tight on the valve of pool body. If not,
please tighten and then inflate. After inflation, the
manometer cannot be removed, otherwise gas will be
released.
The Yellow section shows that more air is needed. The
Yellow
Green section appears when the spa is properly inflated.
Green
White
The White section shows when the spa is over inflated.
Unscrew the manometer cap slightly to release a little air
until it points the green section.
Important: During spa us, the manometer shall only
shows the Green section at all time.
4
13