Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING METHOD
When necessary, the hood may be installed so that it is
supported by the soffit
• The soffit should be constructed with 2x4's
• Determine the installation location on the wall.
• Continue the centerline forward on the bottom of the
cabinet or soffit
• The opening above the hood should allow for the 10"
round duct and clearance to slide the hood back against
the wall.
• The 2x4 studs must be located as shown in the chart, Dim. A. to accept mounting screws
"A" centerline to
stud and keyhole
slots
48"
23-9/16"
36"
17-9/16"
30"
14-9/16"
• Drill 1/8" pilot holes into the studs at the locations shown in the top view illustration.
IMPORTANT: Soffit framing must be capable of supporting up to 150lbs.
Install outlet adapter onto top of hood
IMPORTANT: Check that damper moves freely
• Place the outlet adapter (2x) over the hood exhaust and secure with 4x M4x12mm self-tapping screws
• Use duct tape to seal the connection. Check to be sure the damper moves freely.
"F" hood width at
the top
47-15-16"
35-15/16"
29-15/16"
Require
10-1/2"
minimum
ductwork and hood installation.
Back of hood
opening
for
Top view
Front of hood
Publicidad
