Hudson Grills RC3218 Instrucciones De Ensamblaje página 26

6. When this step completed, install the side burner back
to the firebox, plug the side burner ignition pin wire
into the igniter, followed by the right side shelf with
screws.
Make sure the side burner orifice is aligned with the
side burner. (Fig. 11)
Rear Burner Conversion
1. Remove the 5 screws (3/16-24 x 1/2 in.) at the back of
burner box to detach the rear burner cover from the
rear panel of burner box.
During this process, hold the rear burner cover,
otherwise, it will drop and may break, possibly
causing injury. (Fig. 12)
2. Use wrench to remove the rear burner orifice from the
rear burner and the hose.
Replace it with the NG orifice, and then tighten.
Make sure you are using the correct orifice,
marked "1.44". (Fig. 13)
3. Adjust rear burner's air shutter by loosening the air
shutter screw. (Fig.14)
The settings are:
7/8 in. open for LP gas.
3/8 in. - 5/8 in. open for NG gas.
Orifice
Hose
Air shutter
26
Fig. 11
Rear burner cover
Fig. 12
Rear burner
Fig. 13
Fig. 14