Publicidad
Idiomas disponibles
Idiomas disponibles
Safety advice / Fixing in place / Use
J
U se the product on a stable, flat, undamaged surface (e.g.
a workbench).
J
P lace circular workpieces in the vertical or horizontal V-groove
and clamp them tightly in place. By doing this you will prevent
the workpiece from slipping.
J
T he vice is an aluminium injection casting and therefore is only
impact resistant to limited extent.
J
D o not use extension tubes on the tommy bars. There is the
danger of overloading (fracturing) the spindle.
J
W ear safety gloves and glasses.
Fixing in place
Q
j
A ttach the vice on to a smooth, flat surface.
j
T o do this turn the clamping screw
clamp opening has widened enough.
j
P ush the vice on the supporting surface (table-top, workbench)
and fix it in place on the supporting surface by turning the
clamping screw
Use
Q
Clamping and releasing a workpiece
Q
1. Turn the vice base
joint
in position with the ball joint tommy bar
5
Note: Turn the vice base
project out over the supporting surface. This allows you to
clamp even long workpieces (in the limiting case with one end
on the floor) to work on their ends.
2. Turn the vice jaws tommy bar
jaws
.
2
3. Place the workpiece between the jaws
turning the vice jaws tommy bar
workpiece is tightly clamped.
j
Y ou can now work on the workpiece.
j
A fter completing work on the workpiece, release it by turning
the vice jaws tommy bar
14 GB/IE
.
7
into the desired position and fix the ball
11
so that the ends of the jaws
11
9
anticlockwise.
9
anticlockwise until the
7
anticlockwise to open the
and clamp it by
2
clockwise. Ensure that the
9
.
6
2
Publicidad
