Hinkley 992002F Serie Instrucciones De Instalación página 3

Fig. 7
Fig. 5
Fig. 8
Hanger
ball
Fig. 9
Supply wires
Downrod
Set screws
Lock pin
Fig. 10
Hanger
bracket
Screws
Ceiling
canopy
Canopy
cover
Flat washers
Lock washers
Hex nuts
Hitch pin
Set screw
Downrod
Safety Cable
Set screws
Hitch pin
INSTALLING THE HANGING BRACKET TO
MOUNTING PLATE ASSEMBLY
1. Remove the canopy cover from the canopy by
turning the cover counter clockwise. Remove the
hanger bracket from the canopy by removing the 1 of
2 screws from the bottom of the hanger bracket and
loosening the other one a half turn from the screw
head. This will enable you to remove the hanger
bracket. (Fig. 7)
2. Attach the hanger bracket to the mounting plate
using the two hex nuts and washers and lock
washers provided. (Fig. 8)
DO NOT tighten completely at this point. Allow
hanger bracket to rotate but hold the weight of the
ceiling fan.
3. If you plan to use the downrod packaged with your
ceiling fan, remove the hanger ball by loosing the set
screw, unscrewing the safety pin and unscrewing the
hanger ball. If you are using a different downrod, skip
to the next step. (Fig. 9)
4. Loosen the two set screws in the motor coupling
until the inside channel is clear of the screws. Remove
the Safety Pin and Locking Clip in the top of the motor
coupling. (Fig. 10)
5. Carefully feed the fan lead wires and safety cable
up through the downrod. Thread the downrod into the
motor coupling until the Safety Pin holes are aligned.
(Fig. 9) Next, replace the Safety Pin and secure with
the Locking Clip. Securely tighten both set screws.
(Fig. 10)