Publicidad
2. Install telescopic mounting poles
Step 1. Use thumb or finger to depress the right upper pole spring plunger ball
located at the cable window, pull upper pole upward until your desired
height. Twist upper pole toward the plunger holes direction and engage
the spring ball info the plunger hole and set as shown in fig-1.
Step 2. Repeat with left pole.
Note:
Make sure cable management holes
are facing the rear of base.
Left upper poles
Lower poles
Spring
plunger
Right upper poles
Figure 1
Note:
Slide upper poles up and down to locate
different plunger holes for your desired
height.
Figure 2
TV panel center
height measured
from floor.
1500mm
1450mm
1400mm
1350mm
1300mm
1250mm
1200mm
1150mm
1100mm
1050mm
1000mm
Publicidad
