EN
ITEM CATEGORY
Operating voltage
Air Output Temperature
Warm Air Speed Output
Motor thermal Protection
Heater Thermal Protection
Timing Protection
WARNING
for installation by a qualified service
person. Use 2.0 mm
solid conductor for wiring.
DANGER
ground unit could in serve electrical
shock and/or death.
NOTE: We do not recommend installing this dryer above a basin. if you are installing this
dryer above a basin, please make sure that reflaction wont'occur.
[Type Y attachment]
If the power supply cord is damaged, it must be replaced by the manufacturer or its servi-
ce agent or a qualified person in order to avoid a hazard. Disconnect the fixed wiring only
in accordance with the wiring rules.
TECHNICAL SPECIFICATIONS
110-120 Vac, 50/60 Hz, 7.6-8.4 A, 0.84-1.0 kW
220-240 Vac, 50/60 Hz, 3.8-4.2 A, 0.84-1.0 kW
55 °C (131 °F) – Ambient Temp. 25 °C (77 °F)
95-115 m/s (212.5-257.2 mi/h)
325-500 W
Motor Type
Auto Resetting, Thermostat turns unit off at 95 °C [203 °F]
Heater Element
325-500 W, Adjustable
Auto Resettings Thermostat turns unit off at 85 °C [185 °F],
Thermal fuse cuts unit off at 142 °C [288 °F]
Drying Time
Less than 10-15 seconds
Stand-by Power
0.3-0.4 W
Circuit Operation
Infrared Automatic, self adjusting
Sensor Range
4" to 9" [100 mm to 230 mm], Adjustable; standard 6.69" [170 mm ± 20 mm]
60 seconds auto shut off
Drip Proof
IP24
Isolation
Class 1
GENERAL SAFETY INFORMATION
This product is intended
(AWG NO.14)
2
Failure to properly
PERFORAMCE DATA
WARNING
Disconnect power at the
service breaker before installing or
servicing. Full pole disconnection device
must be incorporated in the fixed wiring
in accordance with the wiring rules.
NON FOR HOUSEHOLD USE - MAY
CAUSE BURNS.
WARNING
All units must be supplied
with a 3-wire service. The ground wire
must be connected to the dryer's
backplate.
6